This is a set of 5 airline clips.

They come as a rows of 16 slots. They are 1/4" thick and are suitable  for either 1/8" or 4 mm air lines.

The clips are 3D printed from our industry leading new PYCABS material. 

The are sized as followed: 3.2 mm diameter for 1/8" tubes and 4.1 mm diameter for 4 mm tubes.

This proprietary design gives the following benefits:

• Ultra light hollow material.
• 50 degrees bend capacity before braking allows you to glue the clip along a circular surface like a fuselage side.
• Superior bonding capability to resin laminates with CA gel. This was one of the major design requirement and these clips outperform by far any other product on the market on that matter.
• Large clipping area giving a very high retaining effect.
• Very technical graphite/ grey look that will perfectly match your Make-it-stone internal grey finish.
• "Hiflow" series: designed so that no pinching of the airline occurs when the tube is in position. This ensure that the full air flow passes through the tube without restriction.

1/8' Airline tube clip demonstration. from Oli Ni on Vimeo.

HD servo wire clip gluing test. from Oli Ni on Vimeo.

Here is a pictures of the HD twisted servo cable clip ( bottom ) compared to the 1/8" clip ( middle ) and 4 mm clip ( top ).

Try this product and you will never come back to other clips again!